Logic device/transceiver/encoder

Logic Type: Binary Counter Direction: Upper Number of Elements: 1 Unit Number of Bits: 14 Reset Method: Asynchronous Counting Rate: 12MHz Trigger Type: Negative Edge Operating Voltage: 3V~18V CMOS 14-stage Ripple Carry Binary Counter/Divider and oscillator

2-Channel, 0.8V to 3.6V Low Power Inverter 6-SC70 -40 to 85

SN74ACT00 Quad 2-Input Positive-NAND Gate

The AC/ACT240 is an octal buffer and line driver designed as a memory address driver, clock driver, and bus-oriented transmitter or receiver to increase printed circuit board density.

TinyLogic High Speed ​​(UHS) Series. Fabricated using advanced CMOS technology, the device achieves ultra-high speed and high output drive while operating over a wide V

SN74ALVC08 Quad 2-Input Positive-AND Gate

The NC7SZ126 is a single buffer with 3-state output, part of ON Semiconductor's TinyLogic Ultra High Speed ​​(UHS) family. The device is fabricated using advanced CMOS technology to achieve ultra-high speed and high output drive while maintaining low static power consumption over a very wide VCC operating range. The device is specified to operate from 1.65 to 5.5V VCC. When VCC is 0V, the input and output are high impedance above ground. The input is tolerant to 6V regardless of VCC operating voltage. In 3-state condition, the output withstand voltage is higher than VCC.

SN74HC573A Octal Transparent D-Type Latch with 3-State Outputs

CD4021B CMOS 8-Stage Static Shift Register

The NC7SV14 is a single inverter with Schmitt Trigger, part of ON Semiconductor's TinyLogic Ultra Low Power-A (ULP-A) series. ULP-A is suitable for applications requiring very high speed, high drive and low power consumption. This product is suitable for a wide low voltage operating range (0.9V to 3.6V VCC) and applications that require more drives and higher speed than the TinyLogic ULP series, yet still provide optimal low power operation. The NC7SV14 is designed to optimize power consumption and speed, using an advanced CMOS process to achieve high-speed operation while maintaining the low power consumption of CMOS.

The high-performance silicon-gate CMOS MC74HC574A has the same pin-out as the LS574. The device inputs are compatible with standard CMOS outputs; pull-up resistors are included for compatibility with LSTTL outputs. Data that meets the setup time requirements is clocked to the output with the rising edge of the clock. The output-enable input does not affect the state of the flip-flops, but all device outputs are forced to a high-impedance state when output-enable is high. Therefore, data can be stored even if the output is not enabled. The HC574A has the same functionality as the HCT374A, but has a trigger input on the opposite side of the encapsulation output, simplifying PC motherboard layout.

CD74HC595 8-Bit Shift Register with 3-State Output Register